Tenants expect high-speed internet in every unit
InvisiLight® makes it possible to bring fiber into existing properties without disruptive construction or major renovations.
A cleaner way to install fiber
STEP 1
Fiber enters the building through a centralized distribution point.
STEP 2
The ultra-thin fiber follows walls and ceilings with a low-profile, adhesive-based installation.
STEP 3
Fiber is routed directly into each unit without opening walls or disrupting the property.
STEP 4
Once installed, the fiber can be painted to blend naturally into the environment with minimal visual impact.
Properties with fiber lease faster, retain tenants longer, and increase in value.
Potentially higher income
Properties with fiber connectivity can command higher rents and retain tenants longer
Make your building smart-ready
Support smart devices, cameras, access control, and connected systems with fiber.
Fiber in every unit
Deliver high-performance internet exactly where residents need it.
Simples installation
Easy to install with no specialized tools or major construction required.
Trusted by broadband providers and property owners worldwide
InvisiLight® is already being used in residential buildings, MDUs, hotels, and historic properties across multiple countries.
Although fiber is very small, it can transmit a virtually unlimited amount of information.
Once it is installed, future speed upgrades take place at the ends of the network, meaning the building should not need to be rewired again. The fiber technology will support future upgrades to higher speeds for decades.
Surveys continually find that access to high speed internet is an important MDU amenity and fiber is the most future-proof way to do that.
InvisiLight Solutions have connected over 1 million subscribers to fiber in homes and apartments – and this proven technology is ideal to bring fiber to the MDU unit.
The installation process is clean and relatively quiet. The process is fast, with limited disruption to residents. Residents have full access to the building and unit during the installation process.
Crews place a small “Point of Entry” module above each door.
They then run a small cord down the hallway or outside the units, dropping a fiber off at each unit.
A fiber is then run from inside each unit to connect the fiber in the hallway.
The process takes roughly 2–3 hours for a 12 unit hallway, and 30–45 minutes inside the unit.
The fiber is a special type designed for use in homes, apartments, and buildings with many bends. It is compliant with the ITU G.657.B3 Recommendation, but is specified to half the bend radius (less bend sensitive). It’s much less bend sensitive than typical ITU G.652.D fibers that are normally used in the outside plant.
Millions of units have already been connected for up to approximately 15 years with this fiber type.
No, product installation is simple. Use the adhesive contained in the syringe supplied in the kit. Additional installation accessories are included. If the cord needs to pass through a wall, a drill will be needed.
It can be installed on almost all common indoor wall surfaces such as brick, wood, drywall, plaster, wallpaper, etc.
Yes.
